Janome JR3000 Series Operation Manual page 76

Setting Type Numbers for Additional Function Data
This sets specific numbers for additional function data to a block of points (between given points) in a
program.
If any point in the block already has the same additional function data set to it, the additional function
data number is replaced with the number specified in common block settings. If the block contains any
point where the specified function cannot be set, that point is not affected.
There are 6 types of additional function data:
• PTP Conditions
• CP Conditions
• Point Tool Data
• Pallet Routines
• Execute Conditions
• Workpiece Adjustments
From the common block settings menu, select
the additional function data type number (e.g.
[PTP Condition Number]) that you want to set,
and enter that number.
NOTE
Please refer to "8.4 Additional Function Data" for more information regarding additional function
data.
F0 (DEL) key: ························· This displays the delete additional function data number entry
F1 (COPY) key: ······················ This displays the source additional function data number entry
F2 (NEW) key: ························ This displays the unregistered additional function number list.
Teaching Pendant Operation
PTP Condition Number
DEL
F0
screen. Enter the number of the point job/additional function data
you want to delete.
screen. Enter the source number and destination number. The
contents of the source point job/additional function data are
copied to the destination number.
Select a number from the list. The new additional function data
entry or selection screen appears. Enter the commands or
parameters. Press the ESC key to set the entered additional
function data to the point and the display returns to the point
settings screen.
75
Enter a number
COPY NEW LIST
F1 F2 F3
Desktop Robot JR3000
1
VIEW
F4