Janome JR3000 Series Operation Manual page 20

SHIFT + CURSOR
ENTR ···································· Displays the entry or selection screen for the highlighted item.
Program numbers
and point numbers
Coordinates
Point type
Point Job
Additional function
data
0 – 9 ································· Each of these keys executes the respective point job data set to
. ··········································· This moves the cursor to the bottommost line.
SHIFT + GO ······················· This executes mechanical initialization.
In this manual, highlighting a certain item and pushing the ENTR key is referred to as "selecting"
that item.
Teaching Pendant Operation
··········· This highlights the item on the bottom of the last page. This key
combination is invalid if the item on the bottom of the last page is
already highlighted or if there is only 1 page.
Push ENTR to display the point number entry screen. Enter a number
here to show the point settings screen for that number.
Push ENTR to display the coordinate position entry screen.
Push ENTR to display the point type selection screen.
Push ENTR to display the numerical entry screen for the registered point
job/additional function data.
If you want to change the point job/additional function data type, enter "0" on
a currently registered point job/additional function data, and set new point
job/additional function data ( CURSOR
them when pushed (keys with no point job data set to them are
invalid.)
key).
19 Desktop Robot JR3000