Janome JR3000 Series Operation Manual page 100

Once the block start number is set, the block
end number entry screen is displayed, as
shown to the right. Enter the end number of the
block you want to delete.
Once the data number range you want to delete
is entered, the delete confirmation screen is
displayed. Select [YES] to perform the delete
operation. Select [NO] to return to the delete
number entry screen.
Press the F3 (LIST) key on the delete
number entry screen to display a list of all the
registered programs. You can also select the
numbers you want to delete from this list.
Teaching Pendant Operation
Enter a number.
Block End Number
F0 F1
Delete OK?
YES
F0 F1
99
LIST
F2 F3
No. 5 – 8
NO
F2 F3
Desktop Robot JR3000
8
F4
F4