Panasonic AFPX-C30R User Manual page 472

WR904 FP-X
Address
R9040 TOOL port mode flag
R9041 COM1 port PC(PLC) link flag
R9042 COM2 port mode flag
R9043 Not used
COM1 port SEND/RECV
R9044
instruction execution flag
COM1 port SEND/RECV
R9045 instruction execution end
flag
R9046 Not used
COM2 port communication
R9047
error flag
COM2 port
reception done flag during
R9048
general-purpose
communicating
COM2 port
transmission done flag
R9049
during general-purpose
communication
COM2 port SEND/RECV
R904A
instruction execution flag
COM2 port SEND/RECV
R904B instruction execution end
flag
R904C to
Not used
R904F
Note) R9040 to R904F can be changed during 1 scan.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Name
Goes on when the general-purpose serial
-
communication is used.
Goes off when the MEWTOCOL is used.
-
Turn on while the PC(PLC) link function is used.
Goes on when the general-purpose serial
-
communication is used.
Goes off when the MEWTOCOL is used.
-
-
Monitors whether the F145 (SEND) or F146 (RECV)
instructions can be executed or not for the COM1 port.
Off: None of the above mentioned instructions can be
On: One of the above mentioned instructions can be
Monitors if an abnormality has been detected during the
execution of the F145 (SEND) or F146 (RECV)
instructions for the COM1 port as follows:
Off: No abnormality detected.
On: An abnormality detected. (communication error)
The error code is stored in DT90124.
-
Goes on if a transmission error occurs during data
-
communication.
Goes off when a request is made to send data,
-
using the F159 (MTRN) instruction.
Turn on when the terminator is received during
-
general-purpose serial communication.
Goes on when transmission has been completed in
-
general-purpose serial communication.
Goes off when transmission is requested in general-
-
purpose communication.
Monitors whether the F145 (SEND) or F146 (RECV)
instructions can be executed or not for the COM2 port.
Off: None of the above mentioned instructions can be
On: One of the above mentioned instructions can be
Monitors if an abnormality has been detected during the
execution of the F145 (SEND) or F146 (RECV)
instructions for the COM2 port as follows:
Off: No abnormality detected.
On: An abnormality detected. (communication error)
The error code is stored in DT90125.
-
Description
executed. (During executing the instruction)
executed.
executed. (During executing the instruction)
executed.