Panasonic AFPX-C30R User Manual page 104

6.1 Tool Port and USB Port
Tool port (RS232C)
This port is used to connect a programming tool.
A commercial mini-DIN 5-pin connector is used for the Tool port on the control unit.
The followings are the default settings set when the unit is shipped from the factory.
- Baud rate ........ 9600 bps
Character bit .... 8 bit
-
Parity check ..... Odd parity
-
Stop bit length .. 1 bit
-
USB connector
The connector is the commercial B type.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Pin No. Signal name
1 Signal Ground
2 Send Data
3 Receive Data
4 (Not used)
5 +5V
This is a connector to connect the programming tool.
Commercial USB cables (AB type) can be used.
Abbreviation Signal direction
SG
SD Unit → External device
RD Unit ← External device
−
+5V Unit → External device
−
−