Panasonic AFPX-C30R User Manual page 208

Communication setting
Item
Communica-
tion protocol
select
Communicati
on mode
Action mode
Common
setting
Baud rate
Note3)
(COM1)
Transmi-
ssion
method
Source port
No.
Server
setting
Note1)
Time out
Destination
IP
Destination
port No.
Source port
Client
No.
setting
Note2)
Time out
Retry time
Note1) Set when the server mode has been selected for the action mode.
Note2) Set when the client mode has been selected for the action mode.
Note3) As the communication between the FP-X and AFPX-COM5 is performed using serial
communication, the baud rate for them should be set to the same value.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Communication protocol of AFPX-COM5
Select TCP or UDP.
Communication mode of AFPX-COM5
Select Computer link or General communication.
Connection mode of AFPX-COM5
Select Client mode or Server mode.
When selecting Computer link for Communication mode, Client
mode cannot be selected.
Baud rate for communicating with the COM1 port of FP-X.
Change the baud rate according to the baud rate for the COM1
port of FP-X.
Select 9600 bps or 115200 bps.
It is valid when selecting UDP in the communication protocol.
Method for transmitting data to partner devices.
Select UNICAST or BROADCAST.
Port number that AFPX-COM5 opens.
Setting range: 1025 to 32767
If AFPX-COM5 not communicate with a destination device
during this setting time (seconds) in the state that connection is
established, connection will be cut.
Setting range: 0 to 1800 s When 0 is set, the connection will
not be cut.
IP address of a destination device
Set an IP address other than 0.0.0.0 and 255.255.255.255.
Destination port number of a destination device
Setting range: 1025 to 32767
Source port number of a destination device
Setting range: 0, 1025 to 32767
When 0 is set, optional.
If AFPX-COM5 not communicate with a destination device
during this setting time (seconds) in the state that connection is
established, connection will be cut.
Setting range: 0 to 1800 s When 0 is set, the connection will
not be cut.
When failed in the connection with a destination device.
Setting range: 0 to 1800 s
Description Default
TCP
Computer link
Server mode
9600 bps
UNICAST
9094
0
192.168.1.100
9094
0
0
15