Panasonic AFPX-C30R User Manual page 217

MEWTOCOL master setting in UDP
Note:
After the AFPX-COM5 is powered on, it will take about 5 seconds for initializing the Ethernet.
Until the Ethernet is initialized, data cannot be transmitted or received. For the Ethernet communication,
programming is necessary to start the communication after 5 seconds since the power turned on.
Generally, as a router does not transmit a broadcast packet, communication over the router cannot be
achieved. Using the broadcast, processing load is applied on all equipment on the network. Confirm that
the broadcast does not affect other equipment before using it.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Item
Communication protocol
Action mode
Baud rate (COM1)
Communication mode
Send type
Destination IP address
Destination port No.
Source port No.
Note1) Specify the same baud rate as the
communication environment setting of the
COM1 port of the FP-X.
Note2) When selecting BROADCAST, the setting of
the destination IP address is not required.
Default
UDP
Client connection
15200 bps/9600 bps
Note1)
Computer link
UNICAST/BROADCAST
Note2)
IP address of destination
1025 to 32767
0, 1025 to 32767