Using The Control Panel Programming Mode - Honeywell IntelliPath Series Installation And Setup Manual

LTE-I Installation and Setup Guide
Each key of the 7720P has two possible functions: a normal function and a Shift function.
To perform a normal key function, simply press the desired key.
To perform a Shift function, press the [shift] key, and then press the appropriate key.
The prompts in this document reflect use of the 7720P Programming Tool. The table below lists
each normal and shift key function.
KEY
BS/ESC
/
N/Y
SHIFT
1/A
2/B
3/C
4/D
5/E
6/F
7/S
8/T
9/X
SPACE
0
#/ENTER
* Active only when the "Exit Programming Mode" prompt is displayed.

Using the Control Panel Programming Mode

Some control panels support programming of the communicator through the control panel
programming mode (e.g., VISTA-128BP). If programming through the control panel, only
the ECP Mode programming options are available. The "mode" questions will not be
displayed, and the mode cannot be changed. For a description of key functions on the
control panel keypad, and how they map to the 7720P Programming tool, refer to the control
panel's Programming Guide.
Xmit
Shift
7720 PROGRAMMING TOOL
A
BS / ESC
1
/
D
4
N / Y S
7
Shift Space
7720P Programmer Tool Connection
Table 3-1. 7720P Normal and Shift Key (shift LED lit) Functions
NORMAL KEY FUNCTION
[BS]: Press to delete entry
[]: Scroll down programming
[N]: Press for "NO" answer
Press before pressing a SHIFT key function. Will light SHIFT LED. LED goes out once a key
is pressed. Press again for each SHIFT function desired.
[1]: For entering the number 1
[2]: For entering the number 2
[3]: For entering the number 3
[4]: For entering the number 4
[5]: For entering the number 5
[6]: For entering the number 6
[7]: For entering the number 7
[8]: For entering the number 8
[9]: For entering the number 9
[SPACE]: For scrolling option list
[0]: For entering the number 0
[#/ENTER]: Starts programming mode;
Press to accept entries
B C
2 3
E F
5 6
T X
8 9
Enter
0 #
SHIFT KEY FUNCTION
[ESC]: Press to quit program mode; also can reset
programming defaults*
[]: Scroll up programming
[Y]: Press SHIFT-Y for "YES" answer
[A]: For entering letter A
[B]: For entering letter B
[C]: For entering letter C
[D]: For entering letter D
[E]: For entering letter E
[F]: For entering letter F
[S]: For entering letter S
[T]: For entering letter T
[X]: For entering letter X
No SHIFT function
No SHIFT function
No SHIFT function
18
7720P
PROGRAM
CONNECTOR