Mounting The Module On The Control Panel - Honeywell CDMA-X Installation And Setup Manual

SIGNAL STRENGTH LED (green)
ON - Satisfactory Signal
OFF - Unsatisfactory Signal
3. Verify the SIGNAL STRENGTH LED (green) remains steady for a few minutes, then mark that mounting
position. Turn power off.

Mounting the Module on the Control Panel

1. Ensure power to the control panel (both AC and battery) is off, then remove the knockout on the top right of the
control panel cabinet.
2. Open the communicator cover. Remove the external antenna port cap attached to the plastic (trim as necessary),
and snap it into the external antenna cable port at the top of the enclosure.
3. Remove the bottom knockout on the enclosure for the threaded mount. Then install the threaded mount so it
snaps into the plastic retaining tabs. Mount the communicator assembly on the cabinet's knockout, and fasten
with the locking nut.
CDMA-X Installation and Setup Guide
– 4 –