Technical Data; Rated Conditions - Siemens SIPART PS2 Operating Instructions Manual

Technical data

12.1

Rated conditions

Rated conditions
Ambient conditions
Ambient temperature
● Permissible ambient temperature for operation
● Height
● Relative humidity
Degree of pollution
Overvoltage category
Degree of protection
1)
Mounting position
Vibration resistance
● Harmonic oscillations (sine) according
to EN 60068-2-6/10.2008
● Bumping (half-sine) according to EN 60068-2-27/02.2010
● Noise (digitally controlled) according to EN
60068-2-64/04.2009
● Recommended range of continuous operation of the entire
control valve
Climate class
● Storage
● Transport
Max. impact energy 1 Joule for enclosure with inspection window 6DR5..0 and 6DR5..1 or max. 2 Joule for 6DR5..3
1)
At ≤ -10 °C (≤ 14 °F) the display refresh rate of the indicator is limited. When using position feedback module, only T4 is
2)
permissible.
The following applies to order suffix (order code) -Z M40: -40 ... +80 °C (-40 ... +176°F)
3)
SIPART PS2 with and without HART
Operating Instructions, 05/2017, A5E00074631-AC
For use indoors and outdoors.
In hazardous areas, observe the maximum permissible am‐
bient temperature corresponding to the temperature class.
-30 ... +80 °C (-22 ... +176 °F)
2)3)
2000 m above sea level. At altitudes greater than 2000 m
above sea level, use a suitable power supply.
0 ... 100%
2
II
IP66 to IEC/EN 60529 / NEMA 4X
Any; in wet environment, pneumatic connections and outlet
opening not upward
3.5 mm (0.14"), 2 ... 27 Hz, 3 cycles/axle
98.1 m/s² (321.84 ft/s²), 27 ... 300 Hz, 3 cycles/axle
150 m/s² (492 ft/s²), 6 ms, 1000 shocks/axle
10 ... 200 Hz; 1 (m/s²)²/Hz (3.28 (ft/s²)²/Hz)
200 ... 500 Hz; 0.3 (m/s²)²/Hz (0.98 (ft/s²)²/Hz)
4 hours/axle
≤ 30 m/s² (98.4 ft/s²) without resonance peak
According to IEC/EN 60721-3
1K5, but -40 ... +80°C (1K5, but -40 ... +176°F)
2K4, but -40 ... +80°C (2K4, but -40 ... +176°F)
12
231