Siemens SIPART PS2 Operating Instructions Manual page 184

Parameter assignment
9.4 Description of parameters
H2.LEVL1 - threshold 1
Adjustment range:
Purpose:
Factory setting:
H3.LEVL2 - threshold 2
Adjustment range:
Purpose:
Factory setting:
H4.LEVL3 - threshold 3
Adjustment range:
Purpose:
Factory setting:
See also
'39.YCLS' Tight closing/fast closing with manipulated variable (Page 157)
184
-40.0C ... 90.0C
-40.0F ... 194.0F
Use this sub-parameter to set the temperature for threshold 1.
The positioner triggers a threshold 1 message if the current temper‐
ature inside the enclosure undershoots threshold 1. This message
is only output if threshold 2 or 3 is not exceeded at the same time.
The process to activate and display this message is described in the
'XDIAG' parameter.
-25.0C
-40.0C ... 90.0C
-40.0F ... 194.0F
Use this sub-parameter to set the temperature for threshold 2.
The positioner triggers a threshold 2 message if the current temper‐
ature inside the enclosure undershoots threshold 2. This message
is only output if threshold 3 is not exceeded at the same time. The
process to activate and display this message is described in the
'XDIAG' parameter.
-30.0C
-40.0C ... 90.0C
-40.0F ... 194.0F
Use this sub-parameter to set the temperature for threshold 3.
The positioner triggers a threshold 3 message if the current temper‐
ature inside the enclosure undershoots threshold 3. The process to
activate and display this message is described in the 'XDIAG' pa‐
rameter.
-40.0C
SIPART PS2 with and without HART
Operating Instructions, 05/2017, A5E00074631-AC