Overview Of Advanced Diagnostics Parameters A To P - Siemens SIPART PS2 Operating Instructions Manual

Parameter
50.PRST
51.PNEUM
52.XDIAG
1)
2)
3)
4)
9.3.3

Overview of advanced diagnostics parameters A to P

Introduction
These parameters are used to set the extended diagnostics functions of the positioner.
Note
Factory setting
Factory-set parameter values are printed in bold in the following table.
SIPART PS2 with and without HART
Operating Instructions, 05/2017, A5E00074631-AC
Function
Preset
Reset all parameters which
can be reset by 'Init', 'PArA'
and 'diAg'.
Reset initialization parame‐
ters '1.YFCT' to '5.INITM'.
Reset parameters '6.SCUR' to
'49. LIM'.
Reset parameters A to P of
the extended diagnostics func‐
tion as well as parameter
'52.XDIAG'.
Pneumatics type
Standard pneumatic block
Fail in place pneumatic block
Operation with boosters
Activation of extended diagnostics
Off
Single stage message
Two stage message
Three stage message
Setpoint turning points only appear when '12.SFCT = FrEE' is selected.
'Normally closed' means: Operation when a switch is open or Low level
'Normally open' means: Action on switch closed or High level
'Normal' means: High level, no fault message
'Inverted' means: Low level, no fault message
'+' means: Logical OR combination
Parameter assignment
9.3 Tabular overview of the parameters
Parameter values
ALL
Init
PArA
diAg
Std
FIP
booSt
OFF
On1
On2
On3
Unit
143