Yagl' Rated Angle Of Rotation Of Feedback - Siemens SIPART PS2 Operating Instructions Manual

Parameter assignment
9.4 Description of parameters
Description:
Factory setting:
9.4.1.2

'2.YAGL' Rated angle of rotation of feedback

Requirement:
Possible settings:
Purpose:
148
Meaning of actuator with normal direction of action:
● Part-turn actuator closes when the drive shaft, positioner shaft
or magnet of the NCS sensor rotates in the clockwise direction.
● Linear actuator closes when the actuator spindle rotates
downwards and the positioner shaft or magnet of the NCS sensor
rotates in the anti-clockwise direction.
Meaning for actuator with inverted direction of action:
● Part-turn actuator closes when the drive shaft, positioner shaft
or magnet of the NCS sensor rotates in the anti-clockwise
direction.
● Linear actuator closes when the actuator spindle rotates
downwards and the positioner shaft or magnet of the NCS sensor
rotates in the clockwise direction.
Additional information:
● The '3.YWAY' Range of stroke (Page 149) parameter is
displayed only for 'WAY', '-WAY', 'ncSLL' or '-ncLL'.
● turn/-turn: The '2.YAGL' Rated angle of rotation of feedback
(Page 148) parameter is automatically set to 90° and cannot be
changed.
● WAY/-WAY: The positioner compensates the non-linearity. The
non-linearity is caused by the transformation of the linear
movement of the linear actuator into the rotary movement of the
positioner shaft. When the lever on the positioner shaft is
perpendicular to the spindle of the linear actuator, the positioner
is factory set to a value between'P49.0' and 'P51.0'.
WAY
Transmission ratio selector and the value set in the '2.YAGL' pa‐
rameter match. Only then does the value shown on the display
match the actual position.
● 33°
● 90°
Use this parameter for a linear actuator. For a linear actuator, set
an angle of 33° or 90° depending on the range of stroke. The current
setting of the actuator is then measured more accurately. The fol‐
lowing is applicable:
● 33°: Strokes ≤ 20 mm
● 90°: Strokes 25 ... 35 mm
● 90°: Strokes > 40 ... 130 mm
Use the mounting kit:
● 6DR4004-8V for strokes up to 35 mm
● 6DR4004-8L for strokes greater than 35 up to 130 mm
SIPART PS2 with and without HART
Operating Instructions, 05/2017, A5E00074631-AC