Option Device Version M12 Connector - Siemens SIPART PS2 Operating Instructions Manual

Connection
5.2 Electrical wiring
5. Tighten the screw
6. Connect the cables of each switch to the lug of the printed circuit board in pairs. Use the
provided cable ties
Figure 5-11
5.2.3

Option device version M12 connector

This section describes which terminal of the devices and option modules listed below is
connected with the respective pole of the M12 connector.
Note
Technical specifications
Observe the specifications for the electrical data in the certificate and/or in section "Technical
data (Page 231)".
84
①
of the transparent cover
③
for this purpose.
①
Screw
②
Cover
③
Cable tie
Connecting the cables
②
.
SIPART PS2 with and without HART
Operating Instructions, 05/2017, A5E00074631-AC