Siemens SIPART PS2 Operating Instructions Manual page 265

Description
Dimensions in mm
A
B
C
①
②
Figure B-5
Procedure
1. Produce the mounting panel
2. Align the sensor to the center of the stroke. Observe the dimensions specified in the figure.
Reference
For information on the scope of delivery, refer to section "NCS sensor scope of delivery
(Page 274)".
SIPART PS2 with and without HART
Operating Instructions, 05/2017, A5E00074631-AC
External position detection with NCS or external position detection system
Mounting on a yoke with fin
Mounting on a yoke with plane surface
Mounting on a yoke with columns
NAMUR mounting bracket IEC 60534 -
not included in the scope of delivery
Assembly panel for Non Contacting
Sensor (NCS) - individual solution; not
included in the scope of delivery
Example of the assembly on a linear actuator with a stroke up to 14 mm (0.55 inch)
③
Non Contacting Sensor (NCS)
④
Hex socket head screw M6x25
⑤
Magnet
⑥
Hex socket head screw M6x12
⑦
Mounting bracket for the magnet - individual
solution; not included in the scope of delivery
②
and mounting bracket
B.2 Non-Contacting Sensor
⑦
individually.
265