Siemens SIPART PS2 Operating Instructions Manual page 267

A
B
C
①
②
③
④
⑤
⑥
⑦
⑧
Figure B-6
Procedure
1. Mount the clamping pieces
spring washers
2. Slide the pick-up bracket
3. Set the necessary length.
4. Tighten the screws so that you can still shift the pick-up bracket
5. Set the center of the pin
next higher scaling value of the lever
on successful initialization if you set the same value at parameter "3.YWAY" when
commissioning the system.
6. Slide the lever
7. Secure the lever
SIPART PS2 with and without HART
Operating Instructions, 05/2017, A5E00074631-AC
External position detection with NCS or external position detection system
Mounting on a yoke with fin
Mounting on a yoke with plane surface
Mounting on a yoke with columns
NAMUR mounting bracket IEC 60534
Pick-up bracket
Clamping piece
Dog pin
Lever
U bracket
Hexagonal screw size M8x20
Hexagonal screw size M8x16
Mounting instructions for linear actuators with a stroke > 14 mm (0.55 inch)
⑬
.
②
④
⑤
onto the shaft
⑤
using the hex socket head screw
⑨
⑩
⑪
⑫
Spring lock washer
⑬
Spring washer A6
⑭
Hexagonal screw size M6x25
⑮
Hexagonal nut M6
⑯
Square-head nut M6
⑰
Hexagonal nut M8
⑱
Shaft
⑲
Hex socket head screw size M6x25
③
to the actuator spindle using the hexagonal screw
into the milled recesses of the clamping pieces.
to the stroke range value specified on the actuator, or to the
⑤
. The actuating distance in mm will be displayed
⑱
up to the mechanical stop.
B.2 Non-Contacting Sensor
Spring washer A8
Washer B 8.4
Washer B 6.4
②
.
⑲
.
⑭
and
267