Required Tools; Moving The Drive - ABB ACH580-01 Hardware Manual

Make sure that the installation site complies with the requirements below:
• The installation site is sufficiently ventilated or cooled to remove the heat away from
the drive. See Losses, cooling data and noise (page
• The operation conditions of the drive meet the specifications given in
conditions (page
• The wall is as close to vertical as possible, of non-flammable material and strong
enough to carry the weight of the drive, see
requirements (page
• The floor/material below the installation is non-flammable.
• There is enough free space above and below the drive to enable cooling air flow,
service and maintenance. See the required free space tables for each of the different
mounting alignments on page

Required tools

To install the drive mechanically, you need the following tools:
• drill with suitable bits
• screwdriver set (Torx, flat and/or Phillips, as appropriate)
• socket set (metric)
• tape measure, if you will not be using the provided mounting template.

Moving the drive

Frames R5...R9: Move the transport package by pallet truck to the installation site.
300).
265).
54 (or page 265).
Mechanical installation 59
273).
Dimensions, weights and free space
Ambient