Figure 31: "Add Mapping Rule" Dialog; 750-658 Can Gateway - WAGO -I/O-SYSTEM 750 Manual

64 Configuration and Parameterization
-
-
-
-
-
-
-
-
[Fix] button: If the button is active, the entered value is copied to the
user data byte of the CAN telegram as a fixed value.
IDE checkbox: If the checkbox is selected, CAN telegrams of type
"2.0B Extended" are sent with 29-bit identifier. If the checkbox is not
selected, CAN telegrams of type "2.0A Standard" are sent with 11-bit
identifier.
RTR checkbox: If the checkbox is selected, CAN telegrams are sent
with activated "Remote Transmit Request Bit". If the checkbox is not
selected, data telegrams are sent.
Send on change checkbox: If the checkbox is selected, a CAN telegram
can be generated and sent if the respective byte changes in the process
image of the output.
Send group drop-down list: The selected CAN telegram can be
assigned to one or 8 send groups.
Cycle time (ms) input field: The cycle time can be entered here. If the
value set is greater than 0 ms, the selected CAN telegram is generated
and sent when the time has elapsed.
[Add] button: Adds the created mapping rule to the list of mapping
rules and closes the dialog.
[Cancel] button: Cancels the process and closes the dialog.

Figure 31: "Add mapping rule" Dialog

WAGO-I/O-SYSTEM 750
Version 1.2.0, valid from FW/HW-Version 01/01

750-658 CAN Gateway

Manual