Load Parameters Into The Application; Figure 21: "Select Data" Dialog - WAGO -I/O-SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-658 CAN Gateway
Pos : 86.4 /Serie 750 (WAGO-I/O-SYST EM)/In Betrieb nehmen/Parametrier en mit WAGO-I/O-CH ECK/Kopi e von Konfigurier en und Par ametrieren mit WAGO-I/O-CHEC K 750-0658 (Fenster "Öffnen + Speic hern") @ 15\mod_1366293586080_21.doc x @ 117303 @ 3 @ 1
9.1.2

Load Parameters into the Application

To load parameters into the application:
Click the [Open] button. WAGO-I/O-CHECK displays the default dialog
1.
for opening files.
2. Select a parameter file.
3. In the "Select data" dialog, select the parameters to be loaded from the file.
Only parameters in the selected file can be selected.
More information on the listed parameters is available in the "Parameters in
the 'Select Data' Dialog".
4. Click the [Load] button.
All selected parameters are loaded in the application. The selected parameters
"Configuration", "Operating Mode" and "CAN Parameters" are also written to the
I/O module.

Figure 21: "Select Data" Dialog

Manual
Version 1.2.0, valid from FW/HW-Version 01/01
Configuration and Parameterization 51