52
Configuration and Parameterization
Parameters in the "Select Data" Dialog
Table 24: Parameters in the "Select Data" Dialog
Check Box
Configuration
Operating mode
CAN parameter
Filter
Mapping rule (input)
Mapping rule (output)
Write all selected data after loading into
the I/O module.
Save permanently.
Coupler/controller restarts if process image size differs!
If the process image size difference between the loaded configuration and
application, the coupler/controller restarts after writing the configuration data.
Pos : 86.5 /Dokumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
WAGO-I/O-SYSTEM 750
Description
If the checkbox is selected, the selected
parameters are automatically written to
the I/O module after loading. This not
applicable if the values to be written are
identical to the values in the
application!
If the checkbox is selected, the selected
parameters are loaded in the
application.
If the checkbox is selected, the selected
parameters ...
•
"Filter"
•
"Mapping rule (input)"
•
"Mapping rule (output)"
... are also written to the I/O module.
If the checkbox is selected, all
parameters are saved permanently after
writing.
Version 1.2.0, valid from FW/HW-Version 01/01
750-658 CAN Gateway
Manual