Firmware/Post Error Codes - IBM RS/6000 44P 270 Service Manual

support for recovery instructions. If recovery is not possible, notify the system owner
that new keys for licensed programs may be required.
3. If a network adapter or the I/O board is replaced, the network administrator must be
notified so that the client IP addresses used by the server can be changed. In
addition, the operating system configuration of the network controller might need to
be changed in order to enable system startup. Also check to ensure that any client
or server that addresses this system is updated.
4. For service processor menus, see Chapter 7, "Using the Service Processor", on
page 149.

Firmware/POST Error Codes

Table 3. Firmware Error Codes.
94
Service Guide
Error Code Description
20A80000 Insufficient information to boot.
20A80001 Client IP address is already in
use by other network device.
20A80002 Cannot get gateway IP address.
20A80003 Cannot get server hardware
address.
20A80004 Bootp failed.
20A80005 File transmission (FTP) failed.
20A80006 Image too big. Ran out of
available firmware memory
resources loading boot image.
20D0000F Self-test failed on device, no
error/location code information
available.
20D00010 Self-test failed on device, cannot
locate package.
20D00011 Instantiate RTAS failed.
Action / Possible Failing FRU
Verify the IP address.
Change IP address.
Go to table using code E174 "Firmware
Checkpoints" on page 75.
Go to table using code E174 "Firmware
Checkpoints" on page 75.
1. Refer to "Boot Problems/Concerns"
on page 90 for general
considerations.
2. Turn off then on, and retry the boot
operation.
3. Verify boot list by using the firmware
SMS multiboot menus.
4. Verify the network connection
(network could be down).
5. Have network administrator verify
the server configuration for this
client.
Check network connection, try again.
Verify boot server configuration.
Check the System Management
Services error log (described in "Step
1020-4" on page 38) for this error code.
The location code (if present) in the
error log entry should identify the
location of the failing device.
Contact your service support
representative for assistance.
Contact your service support
representative for assistance.