Set Address
The Set Address icon allows you to define addresses from which your system unit can
receive RIPL code.
If any of the addresses is incomplete or contains a number other than 0 to 255, an error
message displays when you select the Save icon. To clear this error, correct the
address and select Save again.
Attention:
gateway IP address to [0.0.0.0].
To change an address, press the backspace key on the highlighted address until the
old address is completely deleted. Then enter the new address.
202
Service Guide
Remote IPL Setup
Client Addr
Server Addr
Gateway Addr
Subnet Mask
Save
If the client system and the server are on the same subnet, set the
000.000.000.000
000.000.000.000
000.000.000.000
255.255.255.000
Exit