IBM RS/6000 44P 270 Service Manual page 129

Table 3. Firmware Error Codes. (continued)
Error Code Description
2BA00066 Service processor reports PCI
expansion card VPD module not
present.
2BA00067 Service processor reports PCI
expansion card VPD data
corrupted.
2BA00070 Service processor reports
processor card VPD module not
present.
2BA00071 VPD data corrupted for processor
card in slot J6.
2BA00073 VPD data corrupted for processor
card in slot J8.
2BA00080 Service processor reports
memory card VPD module not
present.
2BA00081 VPD data corrupted for memory
card in slot J3.
2BA00083 VPD data corrupted for memory
card in slot J2.
2BA00100 Service processor firmware
recovery information could not be
written to diskette.
2BA00101 Service processor is not installed,
update canceled.
2BA00102 No service processor update
diskette in drive.
2BA00103 Service processor firmware
update file is corrupted, update
canceled.
2BA00104 Service processor firmware
update file is the same level as
the service processor firmware,
update canceled.
2BA00200 Service processor firmware
update error occurred; update not
completed.
Error occurred during service
processor flash write operation.
Action / Possible Failing FRU
Replace PCI expansion card
Replace PCI expansion card
Replace the processor card(s).
Replace the processor card in slot J6.
Replace the processor card in slot J8.
Replace memory card(s).
Replace memory card in slot J3.
Replace memory card in slot J2.
1. Check diskette media write protect
tab.
2. Replace the diskette drive.
1. Replace I/O board. (See note on
page93
2. Retry operation
Insert the diskette.
1. Obtain new service processor
firmware diskette.
2. Retry operation.
1. Obtain new level of service
processor firmware.
2. Retry operation.
Service processor firmware update error
recovery procedure:
1. Turn the system off.
2. Unplug power cable and then plug
power cable back in.
3. Turn the system on.
4. Retry operation. If problem persists,
replace service processor.
Chapter 5. Error Code to FRU Index
111