Operator Panel; Removal Of Operator Panel - IBM RS/6000 44P 270 Service Manual

Operator Panel

This section covers removal and replacement of the operator panel.

Removal of Operator Panel

1. If you have not already done so, shut down the system as described in "Stopping
the System Unit" on page 224.
2. If you have not already done so, unplug the system unit power cable from the
electrical outlet.
3. If you have not already done so, remove the front cover as described in "Removal
of Covers" on page 226.
4. Remove the retaining screws (4) that secure the operator panel to the front of the
system unit.
5. Slide the operator panel out from the system unit.
6. Remove the screw that secures the audio cable to the operator panel.
7. Disconnect the cables from the rear of the operator panel.
260
Service Guide
Operator
Panel