IBM RS/6000 44P 270 Service Manual page 312

If no, continue with step 3.
3. Does your modem respond to the extended command set (prefixed with &)?
If yes, go to step 5.
OR
If no, continue with step 4.
4. Does your modem respond to:
v ATZ reset command,
v ATZn reset commands, where n can be 0, 1, and so on?
5. Does your modem command set include a test for V.42 error correction at the
remote modem (often called "Auto-Reliable Mode")?
If yes, disable this test. You can use sample configuration files
/usr/share/modem_m0.cfg
OR
/usr/share/modem_m1.cfg as models to help you create a file for your particular
modem. See "Customizing the Modem Configuration Files" on page 295. Go to step
7.
If no, go to step 6.
6. Does your modem respond to:
v AT&F reset command,
v AT&Fn reset commands, where n can be 0, 1, and so on.?
7. You have completed selection of the configuration file.
If your modem configuration selection is not available in the Service Processor
Modem Configuration Menu, you must access it through the Configure Remote
Maintenance Policy Service Aid.
If you find it necessary to adjust any of these configuration files, use the manual
provided with your modem. It is recommended you select settings that enable
hardware flow control and respond to DTR.
Note: Some older modems do not respond to the commands X0 or &R1. You
294
Service Guide
PTSN (for Public Telephone Switched Network). The service processor
expects to use the modem on the public network, so the telephone line
should attach to the PTSN connector.
OR
If ATZ, configuration file modem_z.cfg is recommended. If ATZn, configuration
file modem_z0.cfg is recommended.
Go to step 7.
OR
If AT&F, configuration file modem_f.cfg is recommended.
If AT&Fn, configuration file modem_f0.cfg or modem_f1.cfg is recommended,
depending on which provides the hardware flow control profile.
should edit out these commands from the modem configuration file if yours is
such a modem. See your modem manual for more information.