IBM RS/6000 44P 270 Service Manual page 128

Table 3. Firmware Error Codes. (continued)
110
Service Guide
Error Code Description
2BA00018 EPOW test failure.
2BA00019 IRQ13 test failure.
2BA00024 Service processor reports bad
power controller firmware.
2BA00040 Service processor reports service
processor VPD module not
present.
2BA00041 Service processor VPD is
corrupted.
2BA00050 Service processor reports system
operator panel VPD module not
present or not recognizable.
2BA00051 System operator panel VPD data
corrupted.
2BA00052 Service processor reports node
supervisor VPD data corrupted
2BA00053 Service processor reports node
supervisor VPD module not
present.
2BA00060 Service processor reports I/O
board VPD module not present.
2BA00061 Service processor reports I/O
board VPD data corrupted.
2BA00062 Service processor reports system
board VPD module not present.
2BA00063 Service processor reports system
board VPD data corrupted.
2BA00064 Service processor reports PCI
riser card VPD module not
present.
2BA00065 Service processor reports PCI
riser card VPD data corrupted.
Action / Possible Failing FRU
Replace the I/O board. (See note on
page 93.)
Replace the I/O board. (See note on
page 93.)
Use the system firmware diskette to
reprogram the system firmware.
1. Use the service processor firmware
diskette to reprogram the service
processor firmware.
2. Replace the I/O board. (See note on
page 93.)
1. Use the service processor firmware
diskette to reprogram the service
processor firmware.
2. Replace the I/O board. (See note on
page 93.)
Replace the operator panel control
assembly. (See note on page 93.)
Note: Swap the old VPD module from
the old operator panel control assembly
to the new one.
Replace the operator panel control
assembly. (See note on page 93.)
Note: Swap the old VPD module from
the old operator panel control assembly
to the new one.
Replace node supervisor card
Replace node supervisor card
Replace the I/O board. (See note on
page 93.)
Replace the I/O board. (See note on
page 93.)
Replace the system board.
Replace the system board.
Replace PCI riser card
Replace PCI riser card