Replacement Of Disk Drives - IBM RS/6000 44P 270 Service Manual

Note: On a new hard drive, pull the lever to the front before installing. Ignore the

Replacement of Disk Drives

1. Align the drive with the disk drive cage rails.
2. Slide the drive into the system unit until it connects with the backplane at the rear of
the drive bay.
3. Configure the drive using SMIT. Then wait five minutes for the drive to warm up.
See "Configuration of Disk Drives" on page 247 for instructions on configuring the
drive.
246
Service Guide
arrow printed on the top of the lever that points to the right.
Pull Lever
To Front