Appendix E. Modem Configurations; Sample Modem Configuration Files; Configuration File Selection - IBM RS/6000 44P 270 Service Manual

Appendix E. Modem Configurations

The service processor is designed to place little demand on the attached modem,
thereby increasing the setup and connection success rates.

Sample Modem Configuration Files

Several sample modem configurations files are supplied that either work directly with
your modem, or provide a good starting point for a custom setup, if required. These
files are included on the Sample Modem Configuration Files diskette and in your
Service Processor firmware with the following names:
The sample modem configuration files are located in the /usr/share/modems
subdirectory, if your server is using AIX. A listing of each file is included at the end of
this appendix.

Configuration File Selection

Use the following selection procedures and your modem manual, to determine which of
the configuration files is suitable for your use.
1. Is your modem an IBM 7852-400?
If yes, use modem configuration file modem_m0.cfg and then go to step 7.
Note: The IBM 7852-400 modem has DIP switches on the right side of the unit.
If no, continue with step 2.
2. Is your modem an IBM 7857-017?
If yes, use modem configuration file modem_m1.cfg and then go to step 7.
Note: The IBM 7857-017 modem has two telephone line connections on the back
Diskette File Name
modem_z.cfg
modem_z0.cfg
modem_f.cfg
modem_f0.cfg
modem_f1.cfg
modem_m0.cfg
modem_m1.cfg
See "IBM 7852-400 DIP Switch Settings" on page 296 for the correct switch
settings.
of the unit. One is marked LL (for Leased Line), and the other is marked
Service Processor Firmware File Name
modem_z.sp
modem_z0.sp
modem_f.sp
modem_f0.sp
modem_f1.sp
modem_m0.sp
modem_m1.sp
293