IBM RS/6000 44P 270 Service Manual page 146

Table 3. Firmware Error Codes. (continued)
128
Service Guide
Error Code Description
460000C3 I/O bridge/device internal error
(checkstop).
460000C4 Error from a PCI to non-PCI
bridge chip, indicating an error on
the secondary bus
460000C5 Mezzanine/system bus address
parity error (checkstop).
Action / Possible Failing FRU
1. If a physical location code is
displayed in the operator panel or
by AIX diagnostics, replace the FRU
as indicated by the location code. If
a physical location code is not
available, continue.
2. In the service processor menus, go
to "Read Progress Indicators from
last System Boot". If an arrow is
pointing to a location code replace
the FRU at that location code. If
there is no arrow pointing to a
location code, continue.
3. Go to "MAP 1540: Minimum
Configuration" on page 50.
1. If a physical location code is
displayed in the operator panel or
by AIX diagnostics, replace the FRU
as indicated by the location code. If
a physical location code is not
available, continue.
2. In the service processor menus, go
to "Read Progress Indicators from
last System Boot". If an arrow is
pointing to a location code replace
the FRU at that location code. If
there is no arrow pointing to a
location code, continue.
3. Go to "MAP 1540: Minimum
Configuration" on page 50.
1. If a physical location code is
displayed in the operator panel or
by AIX diagnostics, replace the FRU
as indicated by the location code. If
a physical location code is not
available, continue.
2. In the service processor menus, go
to "Read Progress Indicators from
last System Boot". If an arrow is
pointing to a location code replace
the FRU at that location code. If
there is no arrow pointing to a
location code, continue.
3. Go to "MAP 1540: Minimum
Configuration" on page 50.