Calibrating The Touch Screen Without Using The Touch Screen - Thermo Scientific NITON XL3t 500 User Manual

Calibrating the Touch
Screen Without Using
the Touch Screen
Thermo Scientific
Because there may be a severe issue with the touch screen itself, you may
need to use the buttons below the screen to complete this process. There are
3 single buttons and a 4 way switch located to the rear of the display screen.
The button at the left is the On/Off/Escape button. The button to the right
is the enter button and the center keypad is a 4 way switch.
The 4 way switch has 4 positions, Up, Down, Left and Right. The select and
interlock buttons are not used in this procedure.
Figure 1-22. The Control Buttons for the XL3
1. Please, turn on your XRF analyzer using the On/Off button.
Note From this point please DO NOT touch the touch screen.
2. Press the enter button. You are now at the Radiation warning
screen.
3. Using the 4 way touch pad on the on the cover of the instrument,
move the cursor around the screen by pressing the appropriate
Up down left or right button. Please move the cursor such that
the Yes option is highlighted in green.
4. Press the "enter" button. You are now at the Enter Password
Screen.

Calibrating the Touch Screen Without Using the Touch Screen

NITON XL3 Analyzer User's Guide 1-65