14 WHEELS/TYRES
REAR WHEEL
Removal
WARNING: Ensure the motorcycle is
stabilised and adequately supported, to
1.
Raise and support the rear of the motorcycle to
allow removal of the rear wheel.
WARNING: If the engine has recently
been running, the exhaust system will be
hot. Before working on or near the exhaust system,
allow sufficient time for the exhaust system to cool
as touching any part of a hot exhaust system could
cause burn injuries.
2.
Remove the silencer as described in the fuel
system/engine management section.
1. Rear Wheel
2. Conical spacer
3. Plain washer
4. Belleville washer
5. Nut
6. Clip
3.
To release the wheel, remove:
•
clip,
•
nut,
•
belleville washer
•
plain washer
•
conical spacer.
4.
Remove the wheel (at a slight angle to avoid contact
with the rear footrest).
Installation
1.
Fit the wheel, aligning with the
2.
Hold the wheel squarely in position while fitting:
•
conical spacer
•
plain washer
•
belleville washer, dished face outwards
•
nut
3.
Tighten the wheel retaining nut to 146 Nm, and fit
the clip.
1. Wheel nut
2. Clip
Refit the silencer as described in the fuel
4.
system/engine management section.
14.8
T
location dowels.
4
gaft
M!1 H