Data Link Fault Retry?; Service Data - Dealer - Triumph T595 DAYTONA Service Manual

9 FUEL SYSTEM/ENGINE MANAGEMENT

5. DATA LINK FAULT RETRY?

DATA L !
R F T R y?
If the above is displayed, check that the ignition is
switched on.
If the ignition is already on, the problem may be caused
by bad connections, faulty ignition switch, cable break,
faulty ECM, flat battery etc.
Press the Help key '?' for advice.
Rectify the problem and press the Validation key `*' to
return to `SWITCH ON BIKE IGNITION'.
Press the Validation key '*' again. If the tool accepts that
the problem has been rectified, `SERVICE DATA' will be
displayed.
This is the first of 2 screens for which the operator has to
input information, without which the testing cannot
proceed further.
!? K FAULT
6. SERVICE DATA — DEALER
I
L
Enter your Dealer number as follows:
The number `555555' is displayed, with the cursor
pointing down at the first digit.
Press the `Up' or `Down' keys to change this digit to the
first digit of your dealer code.
Press the Validation key `*'.
The cursor will now re-position over the second digit `5'.
Enter the 2nd digit of your Dealer number in the same
way.
Continue until all 5 digits of your dealer code have been
entered.
NOTE:
• If any digit has been entered incorrectly, press
the `Return' key (.J) to start again.
When all 5 digits have been entered correctly, press the
Validation key '*'.
You must enter a valid Dealer Number to continue. If
you do not know your dealer number, contact
Triumph or your importer for advice.
9.34
SERI CE
DATA
V
5 5 5 5 5 5