Alternator Removal, Inspection And Installation - Triumph T595 DAYTONA Service Manual

16 ELECTRICAL SYSTEM
ALTERNATOR
Removal
Remove the seat and disconnect the batte
1.
negative (black) lead first.
Remove the belly panel and left hand fairing (if
2.
fitted).
Drain the coolant from the crankcase as
3.
described in the Cooling System section.
Detach the water pump hose at its connection to
4.
the crankcase.
Disconnect the cable and the multiplug from the
5.
alternator.
1. Multiplug
2. Cable
Release the alternator by removing the alternator
6.
to crankcase securing bolts.
Remove the alternator, capturing the 4 cush drive
7.
rubbers from the cush drive.
Inspection
Inspect the alternator'O' ring and renew if
1.
damaged / stretched.
Installation
Fit the cush drive rubbers into the alternator cush
1.
drive.
NOTE:
• If necessary, a small amount of petroleum jelly
can be used to hold the rubbers in position.
,
ry
gacq
I
1. Alternator Drive Rubbers
2. Fit the
' 0'
small amount of engine oil.
1. Alternator `O' ring
Fit the alternator and tighten the bolts to 20 Nm.
3.
NOTE:
• Ensure the earth cable is fitted to the rear bolt.
4. Connect the cable and the multiplug to the
alternator.
5. Refit the water pump hose.
Fit a new washer to the coolant drain screw and
6.
tighten the screw to 12 Nm.
Fill the cooling system with the specified coolant
7.
(see section 'Cooling System' for correct filling
procedure).
8. Refit the fairing and belly panel (if removed).
9. Connect the batte
10. Refit the seat.
16.26
TujH
I ^ ^. 7
/
ring to the alternator and smear with a
, positive (red) lead first.
ry