Front Wheel Bearings Removal And Installation; Bearing Tool Selection Chart - Triumph T595 DAYTONA Service Manual

A xi
^' i ^ I M!
FRONT WHEEL BEARINGS
WARNING: Operation with worn or
damaged steering head or wheel
bearings may cause impaired handling and
instability leading to an accident. If in doubt, have
the motorcycle inspected by an authorised
Triumph dealer before riding.
Removal
1. Remove the wheel as described earlier.
2. Lay the wheel on its side while supporting the wheel
on wooden blocks to prevent damage to the brake
disc.
CAUTION: Do not allow the wheel to rest
on the brake disc as this may damage the
disc. Support the wheel on wooden blocks,
equally spaced around the rim, such that the brake
disc is raised above the ground.
3. Remove the circlips from the hub.
4. Using a suitable drift, through the centre of the
wheel, drift out each bearing. Collect the centre
sleeve.
WARNING: To prevent injury, always
wear eye, hand and face protection when
using a drift.
Installation
Refer to the chart below for the correct tool and tool
face to use when inserting bearings.
Bearings are installed by means of a draw bolt
acting on the insertion tool. A support tool is located
on the opposite side of the hub to the insertion tool
and as the draw bolt is tightened, the bearing is
drawn into the hub.
Insert bearings with the marked or shielded side
facing outwards and always fit a new bearing circlip.
1. Tool 3880075-T0301 in position

Bearing Tool Selection Chart

Left Bearing 3880070-T0301
Right Bearing
3880070-T0301
NOTE:
Install bearings with the marked or shielded sides
face out.
14.9
WHEELS/TYRES 14
FRONT
Bearing Support Tool
Insertion Tool
3880075-T0301
Small face to Large face to
bearing hub
3880075-T0301
Small face to
Large face to
bearing hub