11 REAR SUSPENSION -
1. Slide
2. Punch
WARNING: To prevent risk of injury, do
not place fingers or hands inside the
A
slide. The slide is spring loaded and will cause
injury to fingers or hands which become trapped
inside the slide.
11. Use a hammer to apply a sharp blow to the tool
punch 4 times. Rotate the punch by 45° between
each blow.
12. Remove the tool and examine the end of the link pin
to check that is has been securely riveted over.
13. Repeat the riveting operation with the second link
pin.
14. Check that the links can rotate freely around the
pins. If not, the link just fitted must be removed and
discarded and a new link fitted.
15. Adjust the drive chain tension and rear wheel
alignment.
16. Lower the motorcycle to the ground.
11.24
TUPH