^uM ►^
21. Disconnect the speedometer cable at the
instrument end of the cable.
22. Disconnect the electrical connection to both
handlebar switches, and the ignition switch.
23.
Support the headlight casting and remove the
casting retaining bolts. Without further electrical
disconnections, feed the headlight casting
assembly through the frame and rest the
complete assembly on the rear subframe.
24.
On Daytona only, loosen the handlebar pinch
bolts and rotate the handlebars inboard.
Rotate the Handlebars Inboard
25. Remove the top yoke nut using tool T3880300
26. Slacken the top yoke to fork pinch bolts and
remove the top yoke.
27. Remove the headstock bearing adjuster nut.
28. Place a support beneath the front of the swinging
arm.
29. Support the front wheel/fork assembly and lift the
frame off the yoke stem. Collect the front
fork/wheel assembly.
C
Lifting the Frame from the Forks
30. Disconnect the wiring harness from the frame
cross beam.
31. Remove the starter solenoid from it's mounting.
32. Remove the rear suspension unit upper
mounting bolt.
33. Remove the swinging arm and drag link spindles
and separate the frame from the rear
suspension/mudguard assembly.
galo
Lifting the Frame from The Rear Suspension
15.13
BODYWORK/FRAME 15