Triumph T595 DAYTONA Service Manual page 116

3. Refit the bearing to the alternator side of the
crankcase and tighten the two retaining screws to
12 Nm.
4. Refit the alternator spindle and drive taking care to
align all components during installation.
5. Fit service tool 3880040-T0301 to the front
alternator mounting bolt holes.
6. Fit the alternator drive gear to the clutch side of the
alternator spindle. Use a new bolt fitted from the
clutch side.
NOTE:
• The alternator drive gear must be fitted with the
backlash eliminator gear facing inwards.
7. Fit a new nut to the alternator drive housing end
where the bolt head extends through. Hold the nut
and tighten the bolt to 40 Nm.
8. Remove tool 3880040-T0301.
9. Check the alternator `0' ring for damage and
distortion. Replace as necessary.
1. Alternator-
2. `0' ring
10. Refit the alternator and ensure that the earth strap is
correctly located under the alternator bolt. Tighten
the alternator retaining bolts to 20 Nm.
11. Check the starter motor `0' ring for damage.
Replace as necessary.
1. Starter
2. `0' ring
12. Refit the starter motor tightening the starter bolts to
10 Nm.
13. Refit the water elbow to the upper crankcase using
a new gasket. Tighten the water elbow bolts to 12
Nm.
gahb
1. Water Elbow
7.11
TRANSMISSION 7
/1