Table of Contents
Advertisement
l
GENERAL INFORMATION
Disciplines
Switch off the ignition prior to making any connection
or disconnection in the system. An electrical surge can
be caused by disconnecting `live' connections which
can damage electronic components.
Ensure hands and work surfaces are clean and free of
grease, swarf, etc. as grease collects dirt which can
cause tracking or high-resistance contacts.
Prior to commencing any test, and periodically during
any test, touch a good earth to discharge body static.
This is because some electronic components are
vulnerable to static electricity.
Electrical wires
All the electrical wires are either single-colour or
two-colour and, with only a few exceptions, must be
connected to wires of the same colour. On any of the
two-colour wires there is a greater amount of one
colour and a lesser amount of a second colour. A
two-colour wire is identified by first the primary colour
and then the secondary colour. For example, a yellow
wire with thin red stripes is referred to as a `yellow/red'
wire; it would be a `red/yellow' wire if the colours were
reversed to make red the main colour.
Inspection
Disassembled parts should be visually inspected and
replaced with new ones if there are any signs of the
following:
Abrasions, cracks, hardening, warping, bending,
dents, scratches, colour changes, deterioration,
seizure or damage of any nature.
Replacement Parts
WARNING: Only Triumph approved parts
should be used to service, repair or
convert Triumph motorcycles. To ensure that
Triumph approved parts are used, always order
parts, accessories and conversions from an
authorised Triumph dealer. The fitting of
non-approved parts, accessories or conversions
may adversely affect the handling, stability or
other aspects of the motorcycle operation which
may result in an accident causing serious injury or
death.
WARNING: Always have Triumph
approved parts, accessories and
A
conversions fitted by an authorised Triumph
dealer. The fitment of parts, accessories and
conversions by a dealer who is not an authorised
Triumph dealer may affect the handling, stability or
other aspects of the motorcycle operation which
may result in an accident causing serious injury or
death.
WARNING:
approved parts, accessories and
conversions fitted by a trained technician. To
ensure that a trained technician is used, have an
authorised Triumph dealer fit the parts. The
fitment of parts, accessories and conversions by
personnel other than a trained technician at an
authorised Triumph dealer may affect the
handling, stability or other aspects of the
motorcycle operation which may result in an
accident causing serious injury or death.
Service data
The service data listed in this manual gives
dimensions and specifications for brand new, original
parts. Where it is permissible to allow a part to exceed
these figures, then the service limit is given.
The terms of the motorcycle warranty will be
invalidated by the fitting of other than genuine Triumph
parts.
All genuine Triumph parts have the full backing of the
motorcycle warranty. Triumph dealers are obliged to
supply only genuine Triumph recommended parts.
Specification
Triumph are constantly seeking to improve the
specification, design and production of their
motorcycles and alterations take place accordingly.
While every effort has been made to ensure the
accuracy of this Manual, it should not be regarded as
an infallible guide to current specifications of any
particular motorcycle.
Authorised Triumph Dealers are not agents of Triumph
and have no authority to bind the manufacturer by any
expressed or implied undertaking or representation.
1.10
T
MPH
Always have Triumph
Hide quick links:
Advertisement
Table of Contents
