Triumph T595 DAYTONA Service Manual page 182

19. FUNCTION TESTS
Funcrr!Qn
S P k f S f IY 7
BEFORE
TEST
To clear the DTC's, press the Validation key '*'.
`STORED DTCS' will be displayed (see operation 13).
Proceed as before via operations 14 to 17. Scroll to
`YES' and press the Validation key `*' to erase all DTC
data; the MAIN MENU will be displayed again.
NOTE:•
• The fault(s) which caused the DTC's to be set
must be rectified and cleared before continuing
the Function Tests.
• A full list of all the possible DTCs can be found
earlier in this section.
Select `DIAGNOSTICS' menu and `FUNCTION TESTS'
again pressing the Validation key `*' each time.
Because the DTC's have now been erased,
`FUNCTION' TEST' (operation 20) will now be
displayed.
FUEL SYSTEM/ENGINE MANA GEMENT 9
20. FUNCTION TEST
r FS rs
C L!E R R
ACT! ON
Pt nsraurIEnr
LVI
The following Function Tests can be made:
2
3
4 Fuel pump test
5
6
If the fault is electrical, this will then be reported as a DTC.
Instrument Panel test: A signal is sent which should
cause the tachometer to read approximately 7,500 RPM
for 15 seconds, the water temperature gauge to show
100°C for 15 seconds and the fuel gauge (if fitted) to
register 50% full (all simultaneously).
Idle air control valve (IACV) test: A signal is sent which
should cause the valve to move through it's full range of
step positions and then leave it in the park position. The
signal will cause the valve to operate several times. To
detect valve movement, use a stethoscope to listen for
valve operation.
9.41
Funrri;on:
AC
PAL LI E
Instrument Panel
Idle air control valve (IACV) test
Purge valve test
Cooling fan test
Fuel pump priming test
rEsr
__I
PANEL