Sprag Clutch Removal - Triumph T595 DAYTONA Service Manual

TIZ 1 l! M 1' H
10. Refit the water elbow to the upper crankcase using
a new gasket. Tighten the water elbow bolts to 12
Nm.
\
gahb \ \
1. Water Elbow
11. Refill the cooling system as described in the cooling
section.
12. Refit the clutch and clutch cover as detailed in the
clutch section.
13. Top up the engine with the correct grade of engine
oil.
14. Reconnect the alternator multi-plug.
15. Refit any bodywork previously removed.
16. Reconnect the battery, positive (red) lead first.
17. Refit the seat.
/'
G A^
1
SPRAG CLUTCH
NOTE:
• In order to remove the sprag clutch, the engine
must first be removed from the frame and the
two halves of the crankcase separated.
Removal
1. Remove the water elbow from the rear of the upper
crankcase.
2. Remove the starter motor.
3. Remove the input and output shafts from the
crankcase.
4.
Remove the alternator.
5. Remove the alternator rubber shock absorbers
from the alternator drive housing.
1. Alternator Drive Rubber Shock Absorbers
6. Prevent the alternator shaft from turning by fitting
service tool 3880040-T0301 to the front alternator
mounting bolt holes.
i
\ r
[
gacr
1. Service Tool 3880040-T0301
7.9
TRANSMISSION 7
1
^ J
1c)\
%