Table of Contents
Advertisement
11 REAR SUSPENSION
27. Collect the spacer from the recess inside the left
hand frame outrigger.
1. Spacer
2. Frame outrigger
NOTE:
• If the swinging arm is to be replaced, proceed
through paragraphs 28-34.
28. Remove the large circlip securing the caliper carrier
to the hub and detach the carrier.
29. Remove the hub from the left hand side of the
swinging arm.
30. Remove the caliper carrier positioning stud.
a
t
g
g
2
1. Circlip
2. Caliper carrier
3. Hub
4. Swinging arm
5. Caliper carrier positioning stud
31. Remove the road speed sensor bracket (if fitted)
32. Remove the bearing sleeves from both sides.
33. Remove the right hand bearing by drifting through
from the left.
34. Collect the spacer tube.
gagn
1. Seal
2. Circlip
3. Bearing sleeve
4. Ball bearing
5. Sleeve
NOTE:
• The needle roller bearing in the left hand side of
the arm cannot be removed undamaged.
• If the drive chain is being replaced, proceed
through paragraphs 35 to 36.
35. Remove the sprocket cover.
36. Detach the chain from the output sprocket and
remove the chain.
Inspection
1.
Check all swinging arm bearing for damage, pi
and cracks. Replace as necessa
2.
Check the swinging arm for damage. Replace as
necessary.
1
3.
Check the axle bearings for damage, pitting, and
cracks. Replace as necessa
Check all bearing seals for damage, splits etc.
4.
Replace as necessa
5.
Check the chain for wear, damage etc. Replace as
necessary.
6.
Check both sprockets for wear, damage etc.
Replace as necessa
11.16
2
1
6. Seal
7. Needle roller bearing
8. Seal
9. Bearing Sleeve
ry
.
.
ry
9
7
6
^-
tt
ing,
ry
.
ry
.
Hide quick links:
Advertisement
Table of Contents
