Triumph T595 DAYTONA Service Manual page 55

B 6
A
Camshaft Cap Numbering
NOTE:
• The caps are numbered sequentially and must
not be interchanged for a different position on
the head. The camshaft caps on the outside of
the timing chain (known as outriggers) are
marked 'A' for the exhaust and 'B' for the inlet.
• Each cap is located by two dowels which align
the cap to the head. If the caps cannot be
removed using hand pressure, gently tap each
cap with a soft faced tool to release.
28. Lift the cam chain from the exhaust camshaft
sprocket and remove the exhaust camshaft.
29. Repeat the procedure for the inlet camshaft.
30. Remove the bolt from the centre of the cam chain
housing, in the cylinder head.
31. Remove the banjo bolt securing the oil feed pipe to
the head. Discard the copper washers.
1. Oil Feed Pipe
3. Banjo Bolt
32. Remove the radiator and oil cooler as described in
the cooling system section.
5 4
1
3.21
CYLINDER HEAD & CAMSHAFT 3
33. Remove the exhaust downpipes and silencer as
detailed in the fuel system section.
1. Downpipe to Head Fixings
2. Silencer Mounting
34. Note the position of all tappet buckets and shims
such that they can be refitted in the same positions.
Remove all the buckets and shims.
NOTE:
• To prevent the tappets and shims from
becoming mixed, place the shim and tappet
together in a marked container. The marked
components must be refitted in their original
positions.
35. Release the screws securing the fuel injection
throttle bodies to the head. Place the displaced
throttle bodies and idle air control valve on the
crankcase. Discard the gasket.
NOTE:
• It is not necessary to disconnect the throttle
cable from the throttle bodies when removing
the cylinder head.