6. Check the test results.
When the test program is stopped, the number of test loops executed and the number of
errors are displayed.
Confirm that there is no error.
7. Press the Enter key, and then press the "#" and "." ( period) keys.
This key combination switches you from the domain console to the XSCF console.
8. Type the fmdump command or the showlogs error command at the XSCF Shell.
9. Confirm that no errors are displayed in the XSCF console after using the fmdump or
the showlogs error commands.
If an error is displayed, see
page
B-2.
10. Type the poweroff -d 0 command at the XSCF Shell to power off the system.
XSCF> poweroff -d 0 (In this example, the domain ID is 0)
11. Set the mode switch on the operator panel back to Locked, and hand the key to the
system administrator.
12. Close the door of the cabinet and hand the door key to the system administrator.
Chapter 4 Connecting Your Domains to the Network and Running the Oracle VTS Software
Section B.2, "Using Troubleshooting Commands" on
4-11
Need help?
Do you have a question about the SPARC Enterprise M9000 and is the answer not in the manual?