Logging Into The Xscf Shell - Sun Oracle SPARC Enterprise M9000 Installation Manual

XSCF Unit LEDs
FIGURE 3-41
3. Confirm that the ACTIVE LED (1) and READY LED (2) on the XSCFU#0 are lit.
3.6.2

Logging Into the XSCF Shell

To make the initial setting of the XSCF, first use the default user account of the XSCF.
Before an appropriate user account for the user environment is registered, log in by using the
default user account and password. The default user privileges are useradm and platadm.
Log into the XSCF Shell by following the procedure below.
1. When the Login window is displayed, enter the default login name.
login: default
2. When the message to prompt for key switch operation is displayed, perform the
following operations in accordance with the messages.
a. Change the key switch to "Locked" position.
Change the panel mode switch to Locked and press return...
b. Maintain the key switch in the "Locked" position for 5 seconds.
Leave it in that position for at least 5 seconds.
c. Set the key switch back to "Service" position.
Change the panel mode switch to Service and press return...
1 2 3
Chapter 3 Installing the Server 3-51