HP MSR2000 Configuration Manual page 250

[PE1-Pos2/1/0] mpls enable
[PE1-Pos2/1/0] mpls ldp enable
[PE1-Pos2/1/0] quit
# Configure basic MPLS on ASBR-PE 1, and enable MPLS LDP on the interface connected to PE 1.
<ASBR-PE1> system-view
[ASBR-PE1] mpls lsr-id 2.2.2.9
[ASBR-PE1] mpls ldp
[ASBR-PE1-ldp] quit
[ASBR-PE1] interface pos 2/1/0
[ASBR-PE1-Pos2/1/0] mpls enable
[ASBR-PE1-Pos2/1/0] mpls ldp enable
[ASBR-PE1-Pos2/1/0] quit
# Configure basic MPLS on ASBR-PE 2, and enable MPLS LDP on the interface connected to PE 2.
<ASBR-PE2> system-view
[ASBR-PE2] mpls lsr-id 3.3.3.9
[ASBR-PE2] mpls ldp
[ASBR-PE2-ldp] quit
[ASBR-PE2] interface pos 2/1/0
[ASBR-PE2-Pos2/1/0] mpls enable
[ASBR-PE2-Pos2/1/0] mpls ldp enable
[ASBR-PE2-Pos2/1/0] quit
# Configure basic MPLS on PE 2, and enable MPLS LDP on the interface connected to ASBR-PE 2.
<PE2> system-view
[PE2] mpls lsr-id 4.4.4.9
[PE2] mpls ldp
[PE2-ldp] quit
[PE2] interface pos 2/1/0
[PE2-Pos2/1/0] mpls enable
[PE2-Pos2/1/0] mpls ldp enable
[PE2-Pos2/1/0] quit
# Each PE and the ASBR-PE in the same AS can establish an LDP neighbor relationship. Execute the
display mpls ldp peer command on the devices to verify that the LDP session status is Operational.
(Details not shown.)
3. Configure VPN instances on PEs:
For the same VPN, the route targets for the VPN instance on the PE must match those for the VPN
instance on the ASBR-PE in the same AS. This is not required for PEs in different ASs.
# Configure CE 1.
<CE1> system-view
[CE1] interface gigabitethernet 2/1/1
[CE1-GigabitEthernet2/1/1] ip address 10.1.1.1 24
[CE1-GigabitEthernet2/1/1] quit
# Configure PE 1.
[PE1] ip vpn-instance vpn1
[PE1-vpn-instance-vpn1] route-distinguisher 100:1
[PE1-vpn-instance-vpn1] vpn-target 100:1 both
[PE1-vpn-instance-vpn1] quit
[PE1] interface gigabitethernet 2/1/1
241