Configuring A Pw; Configuring A Pw Class; Configuring A Static Pw - HP MSR2000 Configuration Manual

Step
3. (Optional.) Configure a
description for the
cross-connect group.
4. (Optional.) Enable the
cross-connect group.
5. Create a cross-connect and
enter cross-connect view.
6. Configure an MTU for the PW.

Configuring a PW

Configuring a PW class

You can configure PW attributes such as the PW type and enable control word in a PW class. PWs with
the same attributes can reference the same PW class.
To configure a PW class:
Step
1. Enter system view.
2. Create a PW class and enter
PW class view.
3. (Optional.) Enable control
word.
4. (Optional.) Specify the PW
type.

Configuring a static PW

Step
1. Enter system view.
2. Enter cross-connect group
view.
3. Enter cross-connect view.
4. Configure a static PW and
enter cross-connect PW view.
Command
description text
undo shutdown
connection connection-name
mtu mtu
Command
system-view
pw-class class-name
control-word enable
pw-type { ethernet | vlan }
Command
system-view
xconnect-group group-name
connection connection-name
peer ip-address pw-id pw-id
in-label label-value out-label
label-value [ pw-class class-name |
tunnel-policy tunnel-policy-name ] *
383
Remarks
By default, no description is
configured for the cross-connect
group.
By default, the cross-connect group
is enabled.
By default, no cross-connect is
created.
The default MTU is 1500 bytes.
The two PEs on an LDP PW must
have the same MTU configured for
the PW. Otherwise, the PW cannot
go up.
Remarks
N/A
By default, no PW class is created.
By default, control word is
disabled.
By default, the PW type is VLAN.
Remarks
N/A
N/A
N/A
By default, no static PW is
configured.