HP MSR2000 Configuration Manual page 119

LSR Type : Ingress
Service : -
NHLFE ID : 1026
State : Active
Nexthop : 10.1.1.2
Out-Interface: GE2/1/1
# Execute the display interface tunnel command on Router D. The output shows that the tunnel interface
is up.
[RouterD] display interface tunnel
Tunnel4 current state: UP
Line protocol current state: UP
Description: Tunnel8 Interface
The Maximum Transmit Unit is 64000
Internet Address is 8.1.1.1/24 Primary
Tunnel source unknown, destination 1.1.1.9
Tunnel bandwidth 64 (kbps)
Tunnel TTL 255
Tunnel protocol/transport CR_LSP
Last clearing of counters: Never
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
# Execute the display mpls te tunnel-interface command on Router D to display detailed information
about the MPLS TE tunnel.
[RouterD] display mpls te tunnel-interface
Tunnel Name
Tunnel State
Tunnel Attributes
LSP ID
Admin State
Ingress LSR ID
Signaling
Resv Style
Tunnel mode
Reverse-LSP name
Reverse-LSP LSR ID
Class Type
Reserved Bandwidth
Setup Priority
Affinity Attr/Mask
Explicit Path
Backup Explicit Path : -
Metric Type
Record Route
FRR Flag
Backup Bandwidth Flag: -
Backup Bandwidth
: Tunnel 4
: Up (Main CRLSP up, Reverse CRLSP up)
:
: - Tunnel ID
: Normal
: - Egress LSR ID
: RSVP-TE Static CRLSP Name
: FF
: Co-routed, passive
: -
: 1.1.1.9 Reverse-LSP Tunnel ID: 1
: - Tunnel Bandwidth
: -
: - Holding Priority
: -/-
: -
: -
: - Record Label
: - Bandwidth Protection : -
Backup Bandwidth Type: -
: -
110
: 8
: -
: -
: -
: -
: -