Configuring Ldp; Overview; Terminology; Ldp Messages - HP MSR2000 Configuration Manual

Configuring LDP

In this chapter, "MSR2000" refers to MSR2003. "MSR3000" collectively refers to MSR3012, MSR3024,
MSR3044, MSR3064. "MSR4000" collectively refers to MSR4060 and MSR4080.

Overview

The Label Distribution Protocol (LDP) dynamically distributes FEC-label mapping information between
LSRs to establish LSPs.

Terminology

LDP session
Two LSRs establish a TCP-based LDP session to exchange FEC-label mappings.
LDP peer
Two LSRs that use LDP to exchange FEC-label mappings are LSR peers.
Label spaces and LDP identifiers
Label spaces include the following types:
Per-interface label space—Each interface uses a single, independent label space. Different
•
interfaces can use the same label values.
Per-platform label space—Each LSR uses a single label space. The device only supports the
•
per-platform label space.
A six-byte LDP Identifier (LDP ID) identifies a label space on an LSR. It is in the format of <LSR ID>:<label
space number>, where:
The LSR ID takes four bytes to identity the LSR.
•
The label space number takes two bytes to identify a label space within the LSR.
•
A label space number of 0 indicates that the label space is a per-platform label space. A label space
number other than 0 indicates a per-interface label space.
FECs and FEC-label mappings
MPLS groups packets with the same characteristics (such as the same destination or service class) into a
class, called an "FEC." The packets of the same FEC are handled in the same way on an MPLS network.
LDP can classify FECs by destination IP address and by PW. This document describes FEC classification
by destination IP address. For information about FEC classification by PW, see "Configuring MPLS
L2VPN."
An LSR assigns a label for an FEC and advertises the FEC-label mapping, or FEC-label binding, to its
peers in a Label Mapping message.

LDP messages

LDP mainly uses the following types of messages:
16