HP MSR2000 Configuration Manual page 427

# Create a cross-connect group named vpn1, create a cross-connect named ldp in the group, and
create two LDP PWs for the cross-connect to form a multi-segment PW.
[ASBR1] xconnect-group vpn1
[ASBR1-xcg-vpn1] connection ldp
[ASBR1-xcg-vpn1-ldp] peer 192.1.1.1 pw-id 1000
[ASBR1-xcg-vpn1-ldp-192.1.1.1-1000] quit
[ASBR1-xcg-vpn1-ldp] peer 192.3.3.3 pw-id 1000
[ASBR1-xcg-vpn1-ldp-192.3.3.3-1000] quit
[ASBR1-xcg-vpn1-ldp] quit
[ASBR1-xcg-vpn1] quit
4. Configure ASBR 2:
# Configure an LSR ID.
<ASBR2> system-view
[ASBR2] interface loopback 0
[ASBR2-LoopBack0] ip address 192.3.3.3 32
[ASBR2-LoopBack0] quit
[ASBR2] mpls lsr-id 192.3.3.3
# Enable L2VPN.
[ASBR2] l2vpn enable
# Enable global LDP.
[ASBR2] mpls ldp
[ASBR2-ldp] quit
# Configure GigabitEthernet 2/1/2 (the interface connected to PE 2), and enable LDP on the
interface.
[ASBR2] interface gigabitethernet 2/1/2
[ASBR2-GigabitEthernet2/1/2] ip address 22.2.2.3 24
[ASBR2-GigabitEthernet2/1/2] mpls enable
[ASBR2-GigabitEthernet2/1/2] mpls ldp enable
[ASBR2-GigabitEthernet2/1/2] quit
# Configure GigabitEthernet 2/1/1 (the interface connected to ASBR 1), and enable LDP on the
interface.
[ASBR2] interface gigabitethernet 2/1/1
[ASBR2-GigabitEthernet2/1/1] ip address 26.2.2.3 24
[ASBR2-GigabitEthernet2/1/1] mpls enable
[ASBR2-GigabitEthernet2/1/1] quit
# Configure OSPF on ASBR 2 for LDP to create LSPs.
[ASBR2] ospf
[ASBR2-ospf-1] area 0
[ASBR2-ospf-1-area-0.0.0.0] network 22.2.2.3 0.0.0.255
[ASBR2-ospf-1-area-0.0.0.0] network 192.3.3.3 0.0.0.0
[ASBR2-ospf-1-area-0.0.0.0] quit
[ASBR2-ospf-1] quit
# Configure BGP to advertise labeled routes on ASBR 2.
[ASBR2] bgp 200
[ASBR2-bgp] peer 26.2.2.2 as-number 100
[ASBR2-bgp] address-family ipv4 unicast
[ASBR2-bgp-ipv4] import-route direct
418