HP MSR2000 Configuration Manual page 358

# Configure interface Serial 2/1/0, and enable IS-IS, MPLS, and LDP on the interface.
[PE2] interface serial 2/1/0
[PE2-Serial2/1/0] ip address 9.1.1.2 255.0.0.0
[PE2-Serial2/1/0] isis enable 1
[PE2-Serial2/1/0] mpls enable
[PE2-Serial2/1/0] mpls ldp enable
[PE2-Serial2/1/0] quit
# Configure interface Loopback 0, and start IS-IS on it.
[PE2] interface loopback 0
[PE2-LoopBack0] ip address 5.5.5.9 32
[PE2-LoopBack0] isis enable 1
[PE2-LoopBack0] quit
# Create VPN instance vpn1, and configure the RD and route target attributes for it.
[PE2] ip vpn-instance vpn1
[PE2-vpn-instance-vpn1] route-distinguisher 11:11
[PE2-vpn-instance-vpn1] vpn-target 3:3 import-extcommunity
[PE2-vpn-instance-vpn1] vpn-target 3:3 export-extcommunity
[PE2-vpn-instance-vpn1] quit
# Associate interface GigabitEthernet 2/1/1 with VPN instance vpn1, and specify the IPv6
address for the interface.
[PE2] interface gigabitethernet 2/1/1
[PE2-GigabitEthernet2/1/1] ip binding vpn-instance vpn1
[PE2-GigabitEthernet2/1/1] ipv6 address 2002::1 64
[PE2-GigabitEthernet2/1/1] quit
# Start BGP.
[PE2] bgp 600
# Enable the capability to advertise labeled routes to and receive labeled routes from IBGP peer
4.4.4.9.
[PE2-bgp] peer 4.4.4.9 as-number 600
[PE2-bgp] peer 4.4.4.9 connect-interface loopback 0
[PE2-bgp] address-family ipv4 unicast
[PE2-bgp-ipv4] peer 4.4.4.9 enable
[PE2-bgp-ipv4] peer 4.4.4.9 label-route-capability
[PE2-bgp-ipv4] quit
# Configure the maximum hop count from PE 2 to EBGP peer 2.2.2.9 as 10.
[PE2-bgp] peer 2.2.2.9 as-number 100
[PE2-bgp] peer 2.2.2.9 connect-interface loopback 0
[PE2-bgp] peer 2.2.2.9 ebgp-max-hop 10
# Configure peer 2.2.2.9 as a VPNv6 peer.
[PE2-bgp] address-family vpnv6
[PE2-bgp-af-vpnv6] peer 2.2.2.9 enable
[PE2-bgp-af-vpnv6] quit
# Establish an EBGP peer relationship with CE 2, and add the learned BGP routes to the routing
table of VPN instance vpn1.
[PE2-bgp] ip vpn-instance vpn1
[PE2-bgp-vpn1] peer 2002::2 as-number 65002
[PE2-bgp-vpn1] address-family ipv6 unicast
349